# Installer (https://dev.tradieforms.com.au/docs/form-guides/electrical/nsw/nsw-ccew/installer)

The person who did the installation work. What you enter here should match the person responsible for the work on site.

> **Warning**
>
> The Tradie Forms CCEW is retired and direct eCert lodgement is not supported. Use these labels only to understand an existing draft, then complete the current CCEW in the BCNSW portal.

## NSW licence search [#nsw-licence-search]

On a signed-in draft, **Search** on the licence area can look up the **NSW trades licence register** and prefill licence fields.

1. Open the **Installer** section
2. Tap **Search**
3. Enter a licence number or name and pick a result
4. Check name and expiry match the person on site. The register can lag renewals

If search is unavailable or returns nothing, type the details manually. Always verify the result before using it in eCert.

Saved installer details can still help you re-check a draft. Confirm every licence number and expiry against the current register before eCert submission.

## Installer contact information [#installer-contact-information]

- **Required fields** - **First Name** and **Last Name**
- **Optional fields** - **Email**, **Mobile Number**, and **Office Number**

- **First Name:** Installer's first name (required)
- **Last Name:** Installer's last name (required)
- **Email:** Email address
- **Mobile Number:** Mobile phone
- **Office Number:** Office phone

## Installer licence [#installer-licence]

- **Required fields** - At least **Contractor's Licence No.** or **Qualified Supervisor's No.**, with the matching expiry
- **Optional fields** - The second licence set when it also applies

- **Contractor's Licence No.:** Your contractor licence number
- **Licence Expiry:** Expiry date on the licence card
- **Qualified Supervisor's No.:** If applicable
- **Supervisor's Licence Expiry:** Supervisor expiry if applicable

> **Note**
>
> You need at least **contractor licence** or **qualified supervisor** details for the section to complete.

## Installer address [#installer-address]

- **Required fields** - Either **Street Number** or **Lot/RMB**, **Street Name**, **Suburb**, **State**, and **Post Code**
- **Optional fields** - **Floor**, **Unit**, and **Nearest Cross Street**

### Address fields [#address-fields]

- **Floor:** e.g. "Level 2" - leave blank if N/A
- **Unit:** Unit or apartment number - blank for standalone houses
- **Lot / RMB:** Lot or roadside mailbox for rural or new estates
- **Street Number:** e.g. "24" or "24A"
- **Street Name:** Full street name (use "Street", not "St")
- **Nearest Cross Street:** Helps locate rural or unclear addresses
- **Suburb:** e.g. "Parramatta"
- **State:** Usually NSW
- **Post Code:** 4-digit postcode - match the suburb

## Next section [#next-section]

- **[Tester section](https://dev.tradieforms.com.au/docs/form-guides/electrical/nsw/nsw-ccew/tester)** - Who performed testing. This may be the same person as installer.