# Equipment (https://dev.tradieforms.com.au/docs/form-guides/electrical/nsw/nsw-ccew/equipment)

Tick what you actually installed or changed on this job. Only fill ratings and quantities for categories you worked on.

> **Warning**
>
> The Tradie Forms CCEW is retired and direct eCert lodgement is not supported. Use these categories only to understand an existing draft, then complete the current CCEW in the BCNSW portal.

## Equipment installation tracking [#equipment-installation-tracking]

For each equipment type, check the installation box to indicate work was performed. This reveals additional fields for detailed specifications.

- **Required information** - When equipment is marked as installed, provide **Rating** and **Number Installed** for compliance tracking.
- **Additional details** - Use **Particulars** field for specific equipment details, models, or special conditions.

## Equipment types [#equipment-types]

- **Switchboard** - Main distribution boards, sub-boards, and meter panels. Include total amp rating, number of ways, and specify type (e.g., "TPN 250A Main Board", "Single Phase Sub-Board").
- **Circuits** - New circuit installations and modifications. Document circuit protection ratings, types, and note special circuits (RCD protected, RCBO, etc.).
- **Lighting systems** - All fixed lighting installations including LED downlights, fluorescent fittings, and exterior lighting. Include wattage and control methods (switches, dimmers, sensors).
- **Power outlets** - General purpose outlets and dedicated circuits including standard GPOs, 15A outlets, and three-phase outlets. Note special requirements (weather protection, RCD protection).
- **Fixed appliances** - Hardwired electrical equipment such as hot water systems, air conditioning, and pool equipment. Include power ratings and connection types.
- **Generation equipment** - Solar PV, wind, and micro-hydro systems. Include inverter ratings, AC output capacity, and specify grid connection or off-grid configuration.
- **Energy storage** - Battery systems and backup power installations. Include battery capacity (kWh), inverter ratings, and integration with existing or new generation systems.

## Equipment specification details [#equipment-specification-details]

For each installed equipment type, provide:

### Rating information [#rating-information]

- **Electrical rating:** Voltage, current, and power specifications
- **Protection rating:** Circuit breaker or fuse sizes
- **Environmental rating:** IP ratings for outdoor installations

### Installation quantities [#installation-quantities]

- **Number Installed:** Total units or points installed

### Particulars and specifications [#particulars-and-specifications]

- **Manufacturer and model:** For critical equipment identification
- **Special features:** Smart controls, energy efficiency ratings
- **Environmental conditions:** Outdoor, wet area, hazardous location specifications

> **Note**
>
> Include model numbers and specific ratings for major equipment like switchboards, inverters, and large appliances to assist with future maintenance and compliance verification.

> **Note**
>
> If you are unsure how to describe complex switchboard work, align wording with your job sheet and AS/NZS documentation.

## Next section [#next-section]

- **[Meters section](https://dev.tradieforms.com.au/docs/form-guides/electrical/nsw/nsw-ccew/meters)** - Meter installation and removal table.